MP73P+ : Battery charger/analyser
Operators Manual
12.4.3
Paper Roll Replacement
Open the printer door as described above and swing the door open to expose the paper
roll. If any paper remains in the printer, tear the paper off against the paper tear bar
and carefully pull the remaining paper backwards, from the rear of the mechanism
mounting chassis, until the free end emerges.
Press the paper roll retaining
button
inwards using thumb and
forefinger (see Figure 3) and
remove
the empty roll.
Take a new roll of paper, and
separate
the end from the rest of the roll.
Remove
any damaged or gummed part of
the
paper, and cut the free end
squarely
with a pair of scissors or knife,
leaving
a clean straight edge to present
to the
printer mechanism.
Thread the new roll past the
retention button onto the spindle
with the
paper un-spooling in an
anticlockwise direction when
viewed
from the open end (see Figure
4).
Press the paper feed actuator
arm
button until the mechanism grips
the
paper and pulls it through the
front of
the printer (see Figure 5). Turn
the
paper roll so that any loose turns
are
wound snugly against the roll.
Close
the printer door. More paper
may
now be fed through by pressing
the
paper feed button on the front
panel.
12.4.4
Ribbon Cartridge Replacement
Tear off any paper emerging from the
printer.
Open the printer door by pressing the
door
latch inwards.
Place forefinger against the lower
edge of
the mechanism mounting chassis and
thumb
against the chassis door (see Figure
6).
Carefully press the door and chassis
in
a
vertically opposite directions until the
catch is
Doc: DWG1042-12-R18 MB73P+ Operators manual.odt
Page 60 of 64
Copyright Material of Intelligent Charging Limited © 2020
Printed On : 29/11/20
