background image

P-FBC100/EUR (P-FBC110/EUR) Li-Po Charger Manual

This LiPo-charger is for use with Futaba T14SG, FX-22 and FX-32 when fitted with the supplied 
Li-Po batteries only - it is not to be used for any other transmitter or Li-Po battery, as these may 
lack the internal balancing circuitry required for safe charging.

Please note that this charger is different from the type described in the radio manual. Please 
charge the transmitter using the instructions in this manual, not those in the radio manual

Please read this manual carefully before using the charger and follow the instructions.
 

Technical Parameters:

Input:   AC 110-240V  50/60Hz   
Rated output voltage/current: 8.4V/0.5A  (4.2VA. max)
Practical battery specification: 2S Li-Po (2800/3400mAh) 

Battery Charging Times:

The charge time from flat for the 2800mAh battery of the 14SG is around 5 ½ hours, whilst the 
charge time for the 3400mAh battery of the FX22/32 is around 7 hours.

Unplug the AC power and charge connector when the charge light turns green.

Instructions:

Push the charger output plug carefully into the transmitter charging socket, then insert the AC 
mains plug of the charger into the AC power socket. Switch the AC power on, and the charge light 
on the charger will illuminate red, confirming that the battery is being charged.

When the battery is fully charged the charge light on the charger will change to green, this 
confirms that the charge cycle has completed.

When charging is completed, pull out the mains input plug first and then the output jack plug.

Charge Indicator Light Colours:

Red:

 

Normal charging is taking place.

Green:

  Charging completed (or not connected to a battery).

Off:

 

No AC input power.

Safety Precautions:

• Please check the charger’s AC input voltage range matches your local mains AC 

voltage before use.

• This charger is only suitable for indoor use.
• This charger must not be covered when in use, and should be positioned 

well away from any heat source such as a radiator, heater etc to avoiding 
overheating and the risk of a fire.

• This charger should not be used by children unless supervised by an adult.

Summary of Contents for P-FBC100/EUR

Page 1: ...er and charge connector when the charge light turns green Instructions Push the charger output plug carefully into the transmitter charging socket then insert the AC mains plug of the charger into the AC power socket Switch the AC power on and the charge light on the charger will illuminate red confirming that the battery is being charged When the battery is fully charged the charge light on the c...

Page 2: ...charger becomes unplugged remove the battery from the charger as reverse discharging may be possible Only suitable for charging rechargeable 7 4V LiPo batteries with internal balance circuit board Do not use with dry batteries or Nicad NiMH There is a risk of explosion Do not attempt to repair a defective charger yourself Declaration of Conformity Ripmax Ltd hereby declares that this device confor...

Page 3: ...ün aufleuchtet Anleitung Stecken Sie das Ladekabel des Ladegerätes in die Ladebuchse des Senders bevor Sie mit dem Ladevorgang beginnen Danach stecken Sie das Ladegerät in die Steckdose Die LED sollte jetzt rot leuchten als Zeichen für den Ladevorgang Wenn der LiPo Akku voll geladen ist wechselt die LED von rot auf grün als Zeichen dass der Ladevorgang abgeschlossen ist Nach dem Laden ziehen Sie z...

Page 4: ...cht in der Nähe von brennbaren Unterlagen oder Gasen verwenden und nicht unbeaufsichtigt lassen Bei Netzausfall oder gezogenem Netzstecker Akku vom Ladegerät abtrennen da eine gegenseitige Entladung möglich ist Nur zum Laden von wiederaufladbaren 7 4V LiPo Akkus mit internen Balancern geeignet Keine Trockenbatterien oder NC NiMH Akkus laden Explosionsgefahr Defektes Gerät nicht selbst reparieren K...

Reviews: