MP73P+ : Battery charger/analyser
Operators Manual
released. Do not pull the door and chassis apart without first releasing the catch. Swing
the chassis back, leaving the door fully open. This will expose the printer mechanism
and ink ribbon cartridge. Press down on the end of the ink ribbon cartridge marked
‘PUSH’ (see Figure 7) and carefully remove the spent cartridge.
Fit a replacement cartridge, ensuring that the paper lies between the ribbon and the
steel printer platen.
Check that the ribbon cartridge
spindle is
correctly seated over the printer
ribbon
drive shaft, and snap the cartridge
into
place.
If necessary tighten the ribbon by
turning
the faceted disc clockwise by using
fingernail
(see Figure 8).
If there is some paper protruding
from the
front of the printer mechanism,
ensure
that it will pass clearly though the guide channel and past the tear bar before snapping
the chassis shut against the back of the door. Turn the paper roll by hand so that any
loose turns are wound snugly against the roll. Close the door and check the paper flows
freely, using the paper feed button.
12.4.5
Consumables Available
A consumables pack is available containing five 19m rolls of paper and two Epson
ribbon cartridges. Use of this paper is recommended, as most paper rolls from other
sources are too large to fit within the printer housing, and may be of inferior quality
causing dust and wear.
Doc: DWG1042-12-R18 MB73P+ Operators manual.odt
Page 61 of 64
Copyright Material of Intelligent Charging Limited © 2020
Printed On : 29/11/20