1.4 IDENTIFYING KEY FEATURES of your ColorCut LC600 (Rear)
P
Power Switch
...................... Turns the ColorCut LC600 Digital Cutter ON/OFF.
Q
Power Cable Socket
........... Used to connect the cutter to the Mains Power.
R
USB Interface Connector
....
Used to connect the cutter to a computer via the USB
interface.
S
Cable Clamp
....................... Cable Clamp for USB cable
T
Cutting Paper Path
............ Rear exit for paper in the cutting section of the 'Y'
paper path.
The LC600 uses a 'Y'( on its side ) shaped media path when feeding and cutting.
Sheets are stacked in the feeder, which represents 1 arm of the 'Y' shaped media
path. Upon receiving a feed command, the top sheet of media is fed into the cutter
and the entire length of the sheet is fed directly out of the front of the cutter, it is then
reversed back in to the cutter into the second arm of the 'Y' media path (this method
of feeding the media all the way through the device and back, is often used in digital
duplex printers - and is commonly referred to as a Peek-a-boo media path).
U
SDcard
................................ (Engineering feature , not required for customer use)
Intec Printing Solutions - Manual for ColorCut Flatbed series FB520/FB600/FB900/FB1060 ................................................. Page No: 13
P
Q
R
S
T
U
