Intec Printing Solutions - Manual for ColorCut LC600 Sheet fed Label Cutter ........................................................................ Page No: 31
4.2 Connecting to your computer
The Intec ColorCut Pro software includes the USB drivers built into the software. There
is no need to install any addition drivers.
Please note, that operation can not be guaranteed in the following
circumstances:
1) When connection is made through a USB hub or an add-on USB board.
2) When you are using a custom-built computer that has been modified.
For optimal results, please ensure the following:
•
Do not connect or disconnect the USB cable while you are installing the
Intec ColorPro software.
•
Do not connect or disconnect the USB cable while
starting up the computer.
•
Do not connect or disconnect the USB cable while
switching on the cutter.
•
Do not disconnect the USB cable within a 5 second
period of connecting it. (It does not always recognise
the fact it was subsequently disconnected and won’t
reconnect again until you power-cycle both devices)
•
Do not disconnect or connect the USB cable while you are cutting a job,
or while data is being transferred.
Securely plug the USB cable into the USB socket
B
on the rear panel and connect to
your Windows PC.
4.3 ColorCut Pro - USB Connection confirmation
Launch ColorCut Pro, to check the cutter can be
seen correctly.
To launch ColorCut Pro, use the method as
described in section 3.4 (also detailed following)
Use the Windows [START] menu, (or press the
Windows key)
and select the [ColorCut Pro]
icon from the Intec folder
B
.
Alternatively, type the first few letters of
ColorCut Pro in the search bar
C
, to find
the ColorCut Pro application.
You can PIN the ColorCut Pro application to
the START bar, or quick launch taskbar
D
if
required.
B
B
C
D
