Intec Printing Solutions - Manual for ColorCut LC600 Sheet fed Label Cutter ........................................................................ Page No: 46
6.4 The Dual Grip Roller
The Intec ColorCut LC600 engine primarily grips and feeds the media using a 'PINCH'
roller system situated behind the Tool Carriage position.
HOWEVER, to maximise cutting area, and to enable the LC600 to cut closer to the rear
and front edge of your media, the LC600 is also supplied with a supplemental slave grip
roller. This Front Roller, works as a SLAVE to the main roller and is known as the
Dual
Grip Roller
.
NOTE
: The LC600 comes with the default Dual GRIP roller already fitter,
this can be distinguished by the 5 rubber rollers on the shaft. Shipped in
the exit tray, you can find the Narrow Grip Roller, this can be distinguished
by 3 rubber rollers on the shaft.
In normal use it is NOT necessary to change the Dual Grip Roller. When using A4,
or US LETTER media we recommend feeding these LEF (Long Edge First), so that all
rubber rollers are in contact with the media. If you do this, then you will not normally
need to change the dual grip roller.
You should ONLY replace the standard Dual Grip Roller, with the Narrow Grip Roller,
IF you consistently run media that is 260mm or narrower. Running narrow media
can cause the outer rollers to wear unevenly. Therefore, replace the Standard Dual
Grip roller, with the Narrow Dual Grip roller when running media that has a feed edge
<260mm.
Changing the Dual Grip Roller
1.
The Dual Grip front roller is held
in place by the Dual Grip Clamps,
these can be lifted using the Dual
Grip Levers with RED covers at the
front of the LC600
B
.
2.
Open the Dual Drip Lever clamps to remove
the Dual Grip Roller. In order to release
the Dual Grip Lever, press in the ball catch
C
. (You may find it easier to use the end
of a pen to do this).
3.
Once the Ball catch has been depressed,
you can press the red catch down, to open
the Dual Grip Roller clamps.
B
C
ON LINE
/OFF LINE
ENTER
