Intec Printing Solutions - Manual for ColorCut LC600 Sheet fed Label Cutter .......................................................................... Page No: 9
Installation of the LC600 Cutter (Overview of steps)
INSTALLATION
START
INSTALLATION
FINISHED
Unpack the Intec LC600 cutter, check the accessories. Get familiar with the key
features of the LC600. Then position the cutter with enough room to load media and
for the retractable exit tray to be opened.
Unpacking & positioning the LC600
1
Install the supplied ColorCut Pro 3 software for Illustrator or CorelDRAW.
(Install Mac client where applicable)
Install the Software
3
Using the supplied USB cable connect the cutter to your PC. Then
check in the software that the cutter can be seen.
Connect to your Computer
4
Overview of the Blade Holder, and different blade types. Setting the
blade depth. How to install the Blade and Pen Tools.
The ColorCut LC600 Tools
5
Use
TEST
cut to perform a cutting test and adjust blade if necessary.
Load your media and start cutting.
(Please refer to your ColorCut Pro, Cut file design & Daily Operating Manual.
Load media and perform test cut
7
Turn your cutter on, check Cutter appears on Wi-Fi Hot-Spot, launch ColorCut
Pro & calibrate the sensor to cutting position in your software.
LCD Panel & Calibrating the Cutter
6
Configure the Wi-Fi Hotspot to receive the Live video feed
(Install provided Wi-Fi dongle if your PC doesn’t have Wi-fi capabilities
Setup Wi-Fi HotSpot
2