Intec Printing Solutions - Manual for ColorCut LC600 Sheet fed Label Cutter ........................................................................ Page No: 37
Flange
Bracket to
hold tool
Tool holder
5.5 Installing Tools in your ColorCut
The tool carriage is mounted on the beam that travels across the cutting area.
It contains a tool holder which enables you to easily and
efficiently switch between different blade holders if required,
or fit a pen for calibration purposes.
The Tool Holder holds the item described as TOOL1, typically
the cutting blade.
1.
To install a tool into your Intec ColorCut LC600, loosen the tool holder’s thumb
screw
Ⓒ
sufficiently to enable a blade holder or calibration pen to be inserted up
to its flange.
Ⓒ
Tool holder
Bracket to hold tool
Bracket to hold tool
Tool holder
Top
B
Ⓒ
2.
Push the tool, i.e. the Blade Holder or Calibration Pen all the way into the tool
holder until its flange completely touches the upper part of the holder..
Ⓓ
3.
Make sure that the tool bracket is engaged on top of
the tool’s flange
Ⓓ
, and then tighten the screw.
