INSYS WLAN 2.1, Manual

Page: 35 / 98

INSYS WLAN serial 2.1 Initial Operation

Now, enter the following AT commands and confirm the entry with the En
ter key. Each successful entry will be confirmed wit -
h the response "OK".
r
7. re infrastructure mode with
AT#PTY=1.
EMO“.
10.
Enter your WEP key on the first position of the key list (13 hexadecimal bytes
“.
ate
the individual bytes of the key using underscores.
on the same position in the
key list
that all devices use the same key and can communicate with each
11.
e errors with
AT&V.
.1 will be returned.
You will find a list of the entered key at the end of the output.
12. INSYS WLAN serial 2.1 using the command:
AT#RBT.
starts. This will take approx. 5 seconds.
ICS WLAN

The "RF Link" LED at the device is illuminated and the "Signal" LED is illumi-
nnected
to the access point.

connected to the INSYS WLAN
serial 2.1.
.

rs to the commissioning scenario of this manual.
Each false entry generates the response "Error". In such a case, repeat you
entry with corrected syntax.
Configu
8. Configure the SSID with
AT#SSID=“WLAND
9.
Configure the encryption to "WEP 128 bit" with
AT#WEL=2.
separated by underscores) with
AT#KEY0=“aa_bb_cc_01_03_04_05_06_07_04_55_33_22

The key serves as example for your key. Instead, enter your key. Separ

The position of a key in the list is also considered for encryption. The key
must be entered for all devices in the WLAN
other.
Check the key for typ

The complete configuration of the INSYS WLAN serial 2
Restart the

The INSYS WLAN serial 2.1 re

The device returns with the message "INSYS MICROELCTRON
802.11b/g V2.x" and is ready for operation.
nated or blinking. This means that the INSYS WLAN serial 2.1 is co
Configuring the TCP/IP parameters of the INSYS WLAN serial 2.1
The terminal program is not yet started and

SSID, encryption and key are configured as previously described.
1. Click on the "Network" tab.
2 Enter the IP address 192.168.1.27:
AT#IP=192.168.1.27
This IP address refe
35