Initial Operation
INSYS WLAN serial 2.1
HSComm WLAN transfers the values and the message "send settings" ap-
pears in the status bar.
The "RX/TX" LED is blinking during the process.
The message "settings sent" appears.
10.
Click OK in the message.
the device is illuminated and the "Signal" LED is illumi-
nated or blinking. This means that the INSYS WLAN serial 2.1 is connected
to the access point.
YS WLAN serial 2.1
configured as previously described.
.255.255.0.
1234.
The "RF Link" LED at
Configuring the TCP/IP parameters of the INS
HSComm WLAN is not yet started.
SSID, encryption and key are
1.
Click on the "Network" tab.
2.
Enter for "IP address" the IP address 192.168.1.27.
This IP address refers to the commissioning scenario of this manual.
3.
Enter the net mask 255
4.
Enter for "port"
5.
Click on Send.
HSComm WLAN transfers the values and the message "send settings" ap-
The "RX/TX" LED is blinking during the process.
The message "settings sent" appears.
6.
Click OK in the message.
pears in the status bar.
Testing the Configuration
dress
The INSYS WLAN serial 2.1 can now be accessed in the network.
You can test the previously described configuration using these steps.
The INSYS WLAN serial 2.1 is connected to the WLAN and has the IP ad
30
Summary of Contents for WLAN 2.1
Page 1: ...Manual INSYS WLAN serial 2 1 Sep 10...
Page 2: ......
Page 93: ...INSYS WLAN serial 2 1 Declaration of Conformity 19 Declaration of Conformity 93...
Page 98: ......