INSYS WLAN serial 2.1
Initial Operation
9.2
Commissioning with HSComm
9.2.1
Infrastructure Mode
How to commission the INSYS WLAN serial 2.1 in a network with infrastructure
mode using the HSComm WLAN software.
Configuring the WLAN parameters of the INSYS WLAN serial 2.1
It is necessary to configure network mode, SSID (the network name) as well
as encryption method and associated key that the INSYS WLAN serial 2.1
can connect to a WLAN.
The HSComm WLAN software is installed on your PC.
The INSYS WLAN serial 2.1 is connected as described in the previous sec-
tion.
The access point is configured and in operation as described in the previous
section.
1.
Start the program HSComm WLAN.
2.
Click on the Read Settings button to read out the settings from the INSYS
WLAN serial 2.1.
The message "read settings" appears in the status bar of HSComm WLAN.
ings read" appears in the status bar of HSComm WLAN
after some time.
3.
Click on the "WLAN" tab.
4.
Select the "infrastructure" mode.
our WLAN.
7.
our WEP key on the first position of the key list. (13 hexadecimal
that all devices use the same key and can communicate with each
or type errors.
9.
Click on Send.
The message "sett
5.
Enter the SSID (the network name) of y
Observe case sensitivity for the SSID.
6.
Select "128 bit WEP" encryption as security option.
Enter y
bytes)
The position of a key in the list is also considered for encryption. The key
must be entered for all devices in the WLAN
on the same position in the
key list
other.
8.
Check the key f
29
Summary of Contents for WLAN 2.1
Page 1: ...Manual INSYS WLAN serial 2 1 Sep 10...
Page 2: ......
Page 93: ...INSYS WLAN serial 2 1 Declaration of Conformity 19 Declaration of Conformity 93...
Page 98: ......
