Chapter 2: Getting started
98-122988-E
30
CANCEL
:
If you press
C
instead of
OK
, you exit the pointing menu and the display shows the Main
screen with the message
POINT NOW?
.
If the PIN has been accepted, you now have access to the menu system, but you will not be able to
connect to the BGAN network, because the signal strength has not yet been accepted.
Using a fixed EXPLORER
®
700 antenna
You can keep the EXPLORER 700 antenna in a fixed position, using the Pole mount kit for
EXPLORER 700. See Options and accessories on page 156 for information on type number.
Do as follows:
1.
Mount the EXPLORER 700 antenna on a pole
or a wall, for example using the Pole mount
kit.
2.
Connect the antenna cable between the
antenna and the transceiver.
3.
Start up the EXPLORER 700 and point the
antenna as described in Pointing the antenna
on page 26.
4.
Accept the signal strength by pressing
OK
on
the EXPLORER 700 keypad.
5.
Fasten the EXPLORER 700 antenna in the pointed position.
You only have to point the antenna once, when you mount it. Using a computer connected to the
EXPLORER 700, you can set up the EXPLORER 700 to skip pointing at power up. Refer to Pointing
at power up on page 105.
