Chapter 6: Maintenance and troubleshooting
98-122988-E
154
Uploading software
Viewing software version status
To view the version of the embedded software in the EXPLORER 700, select
PROPERTIES
in the
web interface or in the display menus and see
Software information
.
Uploading software using the web interface
You can upload software from the PROPERTIES > Upload window in the web interface.
If you have an Administrator user name and password you do not need to insert a SIM card nor to
enter the PIN to be able to upload software.
For further information, see Uploading software on page 137.
Maintenance
Normal use of the battery
It is recommended
not
to partially charge/discharge the battery several times in a row. Partial
charging/discharging affects the accuracy of the capacity measurement.
Never leave the battery fully discharged for a longer period of time. If the battery is not to be used
for a shorter period of time (1 month), charge the battery to minimum 20 to 30% and remove it
from the EXPLORER 700. If the Battery is stored for more than a month, see Storage at the end of
this section.
Recharging the battery
To recharge the battery, insert it into the EXPLORER 700 and connect the EXPLORER 700 to power.
The indicator left to the display is constantly green as long as the battery is charging. When the
battery is fully recharged, the green indicator is turned off. If the EXPLORER 700 is switched on,
the green indicator will be flashing shortly every 2 seconds.
If a charging error occurs, the green indicator on the EXPLORER 700 flashes rapidly. See the
Troubleshooting Guide on page 157.
Note
Normally the charge time is approximately 2.5 hours. However, if the EXPLORER 700 is
operating while being charged, the charge time is increased.
