Chapter 5: Using the web interface
98-122988-E
Setting up the interfaces
115
Note that changes to your Profiles are not activated until you click Activate.
14. Click
Activate
if you want to activate the changes to your Profiles.
Port forwarding
Port forwarding enables you to setup a server connected to the EXPLORER 700 while the terminal
is in Router mode. Without port forwarding it would not be possible to contact the server from the
internet.
For information on how to set the terminal in Router mode, see Configuring the LAN interface on
page 112.
The following example shows how to allow internet access to a mail server (smtp) connected to the
terminal. The mail server in this example has the IP address 192.168.0.100.
1.
Select
LAN > Port forwarding
in the left navigation pane.
2.
Select
Enabled
to globally enable port forwarding.
3.
Type in the port number of the
Incoming port
.
4.
Type in the
Destination IP
address, which in this example is the IP address of the mail server:
192.168.0.100.
5.
Type in the
Destination port
number.
6.
Repeat step 3. to step 5. to set up port forwarding to additional servers.
