Chapter 2: Getting started
98-122988-E
22
Powering the EXPLORER
®
700
Automatic power up
The default behavior of the EXPLORER 700 is to power up automatically when you connect the
power cable. If you wish, you can change this power up mode, so that the EXPLORER 700 is only
powered if the Power button is pressed.
For further information on power up mode, see Setting the power up mode on page 46 or Power up
behavior on page 105.
Switching the EXPLORER
®
700 on/off
To switch on
the EXPLORER 700,push the
Power button next to the display and hold it
down until the green Power indicator lights up.
It normally takes one or two seconds.
After switching on the EXPLORER 700 you will be
prompted for a PIN (Personal Identification
Number), unless the PIN is disabled (e.g. using
the BGAN LaunchPad).
For information on the options after power on, see
the next section.
To switch off
the EXPLORER 700, push the Power button again and hold it until the display shows
SWITCHING OFF...
.
WARNING!
When the EXPLORER 700 is powered on, stay clear of the antenna front!
The antenna emits radio frequency energy,
not only
when a call or data session is in
progress. Always keep a minimum distance of 1 m from the antenna front.
Power
button
Power
indicator
