July 14, 2013
INFODRAW MRS-400 User Manual v5.4.1
128
In order to trigger an
Input
signal you need to close a connection between the following
wires on the “GPIO/PTZ Cable”:
Port 1) Input 1 wire
and
GND wire.
Port 2) Input 2 wire
and
GND wire.
Port 3) Input 3 wire
and
GND wire.
Port 4) Input 4 wire
and
GND wire.
Once an Input Sensor is triggered, the
“Sensor
number
” signal on the left hand side will light
up. The pre-set trigger actions will also commence accordingly. If you selected recording as a
trigger action, the message/s
"S" “M”
“D”
will appear at the top right hand side of the video
stream.
The statuses of the Input signals are
viewed in the MRS-400 Device tree on
the left hand side under
“Sensors”
.
Sensor 1
= Input 1
Sensor 2
= Input 2
Sensor 3
= Input 3
Sensor 4
= Input 4
