Inficon HAPSITE ER, Operating Manual, Page: 407 / 436

INFICON Maintenance | 17
074-471-P1E HAPSITE ER Operating Manual 407 / 436
If the Service Module has been in storage, refer to HAPSITE ER Service Module
operating manual, Chapter 4, section 4.2.1, Setting Up the Service Module, on page
4-2 before continuing.
HAPSITE ER must be turned on before continuing (refer to HAPSITE ER Service
Module operating manual, Chapter 5, section 5.4, Starting Up HAPSITE ER on the
Service Module, on page 5-9).
Physically attach HAPSITE ER to the Service Module (refer to HAPSITE ER Service
Module operating manual, Chapter 5, section 5.2, Placing HAPSITE ER on the
Service Module, on page 5-2).
HAPSITE ER can be electronically attached to the Service Module using the IQ
Software, or using the HAPSITE ER front panel. Refer to the appropriate HAPSITE
ER model operating manual for more instruction on front panel usage.
CAUTION
When operating the Service Module, the vents must be kept clear to
allow free airflow. Air flows from right to left through the Service Module
to allow cooling of the pumps. A blockage can prevent the air from
cooling the pumps properly and may cause the over-temperature
protection sensor to automatically shut down the pumps.
17.5.1 Attaching HAPSITE to the Service Module Using IQ
Software
1 Make sure that HAPSITE ER does not heat, or is in the NOT READY state. As
soon as the HAPSITE ER screen is displayed, tap STOP PREPARE or using
◄▲▼►, highlight STOP PREPARE and tap OK SEL .