IMO HD2 IP Series, Instruction Manual

Page: 159 / 361

HD2 IP55 High-ingress Protection Series
Function parameter list
-145-
Function
code
Name Description
Default
value Modify
SB1
FWD
Sln
REV
COM
SB2
SB3
Sln FWD REV
Running
direction
ON OFF→ON
ON Forward
OFF Forward
ON
ON
OFF→ON
Reverse
OFF Reverse
ON→OFF
/ /
Decelerate
to stop / /
Sln: 3-wire control, FWD: Forward running, REV:
Reverse running
Note: For dual-line running mode, when
FWD/REV terminal is valid, if the inverter stops
due to stop command given by other sources, it
will not run again after the stop command
disappears even if the control terminals
FWD/REV are still valid. To make the inverter run
again, users need to trigger FWD/REV again, eg,
PLC single-cycle stop, fixed-length stop, and valid
STOP/RST stop during terminal control.
(see P07.04 ).
S1 terminal These function codes define corresponding delay
of the programmable input terminals during level
variation from switch-on to switch-off.
Si electrical level
Si valid invalid valid
invalid
Switch-on Switcn-off
delay delay
Setting range: 0.000–50.000s.
Note: After a virtual terminal is enabled, the state
of the terminal can only be changed in
communication mode. The communication
address is 0x200A.
P05.12 switch-on 0.000s ○
delay
S1 terminal
P05.13 switch-off 0.000s ○
delay
S2 terminal
P05.14 switch-on 0.000s ○
delay
S2 terminal
P05.15 switch-off 0.000s ○
delay
S3 terminal
P05.16 switch-on 0.000s ○
delay