imagistics DL170, Operating Manual

Page: 46 / 157

2.14
Basic operation
Using the bypass tray
When you need to use a size of paper not currently loaded in your machine’s paper
cassette(s), or when you want to use a special type of paper (such as transparency
film), use the bypass tray.
Important: If loading transparency (OHP) film into the bypass tray, be sure that
the sheet is designed for laser printers and not for copiers. Also, be
sure that the film does not have a paper backing and/or a leading
strip. If it does, remove the paper backing and/or strip before insert-
ing. Only film should go in, not film with any backing or strip.
1
Either insert the document in the
ADF
or place it on the
FBS
glass.
2
Place the paper, OHP, etc. in the bypass tray.
See the table of “Acceptable paper size and cassette capacity” on page 1.8 and
“Loading paper in bypass tray” on page 1.10 for more information.
Note: Place the original document in the same orientation as the paper in
the paper source (which you’ll select in step 5, below).
3
Press
PAPER SIZE
to select the bypass tray until the
bypass tray indicator lights on the control panel.
4
If necessary, select desired resolution, contrast,
reduction/enlargement ratio.
5
Press
START
to begin the copying process.
Memory overflow message
If too much information is stored in your machine’s memory, a “Memory Overflow”
message may appear on the
LCD
:
This appears because (1) too many pages have been stored in the memory, or (2)
the pages that are stored have too much information on them.
If this message appears, press
START
to tell your machine to copy pages already in
memory, or press
CANCEL
to delete the current job (but not previous operations).
Note: If you don’t make a selection within 60 seconds, the machine will automati-
cally print the document stored in the memory during the current operation.
If the paper runs out while copying
When your machine runs out of paper, it beeps, the red light
of the printer status lights glows and the
LCD
shows which
source has run out of paper – the 1st cassette, 2nd cassette
(optional) or the bypass tray.
In this example, the machine runs out of the paper in the 1st
cassette:
If you want to cancel the current copying job, press
STOP
. Otherwise, supply the
paper to displayed paper source to resume the copying.
1st Cassette
Please Supply Paper
Memory Overflow
Start Or Cancel