Ikarus OSD Connections
Here you can see identified the different "Ikarus OSD” connectors , and the function of each of
the pins of these connectors. Please pay special attention when you connect the rest of components. In
some pins may have 12v voltages that could cause irreparable damage to the GPS , R/C receiver, video
cameras and video TX. Make sure you understand the function of each pin. Take special care not to
cause any short circuit between different power outputs, could damage the circuit.
Top View
Top view
1. Connections for camera (1 and 2) and video transmitter.
2. Motor and Rudder input connections (No-PPM) / Elevator, Aileron and Pan Output (PPM).
3. Motor, Rudder and tilt output connection. (Tilt only in PPM).
4. Potentiometer to adjust the intensity of telemetry on video.
5. USB connector for configuration.
6. Reset (Yellow and Black) / Debug (not used by end user).
7. IR sensor connector for stabilization (3.3V).
8. GPS Connector (5V) and servo control input (IN Vservo) + RSSI.
9. Video and Motor Battery connector
10. Voltage selector for video cameras and transmitters.
© Ikarus Team Sevilla 2010
Page. 7/60
