•
Save File: Saves in a file the current OSD configuration.
•
Load File: Read from a file the OSD configuration. It will not updated the OSD until you click
on "Update"
•
OSD Reload: Read the current configuration from OSD. All changes made in the screen and
not updated in the OSD will be lost.
•
Read GPS: Read from OSD the home position, only if the GPS position is fixed correctly.
•
Update: Update the OSD with the settle values.
Update Ikarus OSD Firmware
Before updating "Ikarus OSD" using the serial port, we must enter in programming mode.
This can be done using the transmitter and navigating through "Ikarus OSD" menus, or by an order of
the USB port when connected to your computer. Once you enter programming mode, "Ikarus OSD"
turn off interrupts and wait for firmware to be received on serial port. When you push the update
button, is send to OSD the starting order. Once the serial port receives the starting order, it delete the
"Ikarus OSD" firmware, excepting the update routine, and start recording the new firmware. At this
point, it’s very important not to interrupt the operation, or OSD will not start again. Once you have
completed the OSD update, it will restart automatically.
•
Serial COM Port: Specifies the serial port where "Ikarus OSD" it’s connected. The serial port
speed is automatically set to 115200 bps.
•
File: Indicates the file name with the new firmware version. If not file it’s found or not
specified any file name it will proceed to update with the OSD version of embedded in the PC
application.
•
Entry Mode: Send to OSD a command to enter in programming mode. Once you have entered
in programming mode it will disconnect the USB port. To exit this mode it’s necessary to reset
the OSD.
•
Update Firmware: Proceed to update "Ikarus OSD" by the computer's serial port.
© Ikarus Team Sevilla 2010
Page. 18/60
