Configure IR Sensor
This wizard allows to easily configuring the IR head used for stabilization. This configuration
will depend on how you place the sensor on the plane, and its orientation. You can place it in any of the
16 possible, straight or crossover depending on the aircraft type.
The steps to perform the calibration are:
•
Place the sensor away from any heat source and set the center values.
•
Once set, put your hand or a hot object in front of the plane so that the drawing displayed in red
the sensor or sensors activated. Press set.
•
Then place your hand over the sensor or sensors attached to the right of plane. Once you check
that they are correct activated, press Set.
•
Press END when done. If the "END" bottom is not active, it’s because the activation of sensors
has not been adequate. Repeat from the point where you make the error.
© Ikarus Team Sevilla 2010
Page. 33/60
