Calibrate Servos
This screen sets the travel for the different servo channels. You can access to this screen starting
OSD with control channel at minimum (below 900ms).
To do this move all the channels along its entire travel. You can not leave this screen while one
of the two ends of the control channel (CTRL) continues marking 1500, so it is recommended that you
leave the channel to the end. When you spend a few seconds without changing the maximum or
minimum of any channel, this screen will start flashing. After a few seconds without any changes, it
will exit the screen saving the values.
•
CTRL: Control channel.
•
AIL: Aileron channel (it's only shown in PPM mode)
•
ELE: Elevator channel (it's only shown in PPM mode)
•
THR: Motor channel
•
TAIL: Rudder channel
© Ikarus Team Sevilla 2010
Page. 52/60
