IFM Ecomat 300 AS-i Series, Basic Device Manual

Page: 243 / 280

ifm Basic Device Manual AS-i ControllerE M4 Target V15 2015-10-30
Error description AS-I system errors: error codes E10...E32
243
Error message Cause(s) Remedy
E22 Slave 0 detected
The master is in the "protected mode"
and detects a slave with the address 0
on the AS-i bus.
This message is only generated if the
profile of the missing slave on the AS-i
bus is identical to the profile of the slave
with the address 0.
► Change master to "configuration
mode":
→ page
116 , chapter How are the
operating modes for the AS-i master
selected?
E23 Slave 0 bad profile
The master is in the "protected mode"
and detects a slave with the address 0
on the AS-i bus.
This message is only generated if the
profile of the missing slave on the AS-i
bus is different from the profile of the
slave with the address 0.
► Check and replace slave.
► Project slaves again:
[Menu] > [Quick Setup]
→ page
134 , chapter Finish
configuration
E24 Autoaddress not enabled
The master is in the "protected mode"
and detects a slave with the address 0
on the AS-i bus.
This message is only generated if the
profile of the missing slave on the AS-i
bus is identical to the profile of the slave
with the address 0, the "automatic
addressing" in the master, however,
was not activated.
► Activate "automatic addressing" in
the master:
→ page
127 , chapter Automatic
addressing of individual slaves
E25 Config. error
The master is in the "normal operating
mode" and detects a projection error.
Possible causes:

The profiles of the detected slaves
are different from those of the
projected slaves.

One or more slaves are additionally
detected on the AS-i bus.

One or several slaves are missing
on the AS-i bus.
► Check the detected and projected
slave profile in the menu [Slave
Info].
→ page
222 , chapter Display of slave
data
► Check the entries of slaves in the
lists LAS, LDS, LPS, LPF in the
menu [Slave Lists].
→ page
178 , chapter Display of
detected slaves (list)
→ page
180 , chapter Display of
projected slaves (list)
→ page
183 , chapter Display of active
slaves (list)
→ page
186 , chapter Display of slaves
with periphery fault (list)
E26 Generic Periphery fault
The master is in the "mormal operating
mode" and detects that at least one
slave on the AS-i bus signals a
periphery fault.
→ page
186 , chapter Display of slaves
with periphery fault (list)
→ page
189 , chapter Display of slave
with periphery fault