IFM Ecomat 300 AS-i Series, Basic Device Manual

Page: 190 / 280

ifm Basic Device Manual AS-i ControllerE M4 Target V15 2015-10-30
Operation Detection of an unknown slave address
190
13.8 Detection of an unknown slave address
If the address of a connected slave is not known, you can easily find out the slave address:
1.
> The LED [PROJ] is out.
► If the LED [PROJ] lights, change the master to "protected mode".
→ page
116 , chapter How are the operating modes for the AS-i
master selected?
► Remove the unknown slave from the bus.
M
M
E
E
N
N
U
U
0
U
U
S
S
E
E
R
R
2. E25 ASi1
Config. Error
> The display on the left appears instead of the ifm start screen:
"Configuration error"
> LED [CONF/PF] lights
Cause: Slaves which the controllere has in its projection list cannot be
found on the bus.
Note : error description
→ page
239 , chapter Error description
► Press [▲] to scroll to the error screen
M
M
E
E
N
N
U
U
1/2
▲
!
▼
U
U
S
S
E
E
R
R
3. E25 ASi1 Slv.7
Slave not present
> Display of error message:
"AS-i master 1: slave 7 not present"
In this
example : The unknown slave has the address 7.
► Connect the removed slave again
M M E E N N U U
2/2
▲
!
▼
U U S S E E R R
4.
> That's it: The ifm start screen is displayed again
M M E E N N U U
0
U U S S E E R R