ifm
Basic Device Manual AS-i ControllerE M4 Target V15
2015-10-30
Error description
AS-i master command errors: error codes M01...M44
252
Error message
Cause(s)
Remedy
M07
Writing to slave failed:
1. The attempt of the master to
readdress a slave to the new target
address failed.
► Repeat command.
2. Writing the "extended ID code 1" to
slave 1 failed.
Example
: attempt to readdress an
A/B slave to another address.
► Repeat command.
M08
New address temporary stored
During the readdressing of a slave the
new address could not be written to the
slave because the slave is no longer
detected on the AS-i bus.
Possible causes:
1. Double addressing
► Remove one of the slaves with
double address.
► Readdress remaining slave.
► Connect removed slave again.
2
Major bus interference
► Remove cause of the interference.
M09
Extended ID1 temporary stored
While writing the "ID Code 1" to the
slave the code could not be written to
the slave because the slave is no
longer detected on the AS-i bus.
Possible causes:
1. Double addressing
► Remove one of the slaves with
double address.
► Readdress remaining slave.
► Connect removed slave again.
2. Major bus interference
► Remove cause of the interference.
M10
Slave not in LAS
The master detects that a slave has not
been activated.
Possible causes: The slave profile in
the projection data is not identical to the
profile of the detected slave and the
master is in the "protected mode”.
► Change master to the
"configuration mode":
operating modes for the AS-i master
selected?
► Check and replace slave.
► Project slaves again:
[Menu] > [Quick Setup]:
