IFM Ecomat 300 AS-i Series, Basic Device Manual

Page: 226 / 280

ifm Basic Device Manual AS-i ControllerE M4 Target V15 2015-10-30
Operation Set output values
226
13.23 Set output values
For testing it can be useful to set the value of an output without influence by the PLC program. The
controllere helps you.
WARNING
Risk of personal injury! Risk of material damage to the machine/plant!
After the change of the slave outputs the output values remain unchanged.
The output values only change in the following cases:

Manual new setting of the outputs via Slave Setup

Starting the PLC program - the program processes the outputs

Switching the controllere off and on again
► Secure the concerned area.
► Only trained personnel is allowed to set outputs manually.
► Switch the outputs off again immediately after the end of the test.
NOTE
Password level 2 required
→ page
142 , chapter Password setting
NOTE
Changes to the outputs are not effective in the following cases:

The PLC is in the RUN mode (LED [PLC RUN] lights).

AND: The corresponding outputs are processed by the PLC.

Changes of digital outputs on analogue modules.

Changes of analogue outputs on digital modules.
► Switch PLC to the operating mode STOP
→ page
118 , chapter How are the operating modes for the PLC selected?
> LED [PLC RUN] flashes
[MENU] > [Slave Setup] > select master > select slave
1.
► Press the key [MENU]
M M E E N N U U
0
U U S S E E R R