ifm
Basic Device Manual AS-i ControllerE M4 Target V15
2015-10-30
Set-up
Set the baud rate of the serial interface
124
11.1.2
Connect the programming device
RS-232C
To connect the PC with the programming software to the serial interface RS-232C of the controllere,
you need the programming cable with 1 Sub-D-9 connector (female) and 1 RJ11 connector:
→ Article no. E70320
► Connect the PC to the controllere using the above-mentioned cable
► Start the programming software CoDeSys
®
2.3 on the PC
► Create a new project in CoDeSys
®
► Set target system:
1.
► Click on the symbol [▼]
2.
► Select a valid target for the controllere
and confirm with [OK]
3.
► Confirm with [OK]
4.
► Confirm the new POU "PLC_PRG" with
[OK]
5.
► Replace "???" by "TRUE" in the first
network
► PC key [Enter]
>
The first "program" is provisionally
finished.
6.
► Menu sequence [Online] >
[Communication Parameters]
► Mark the uppermost line in the column
[Channels]
► Click [New…]
