94
ifm
Device Manual SmartSPS AC14 with EtherNet/IP interface (AC1421, AC1422), Firmware 3.1.2
2015-11-30
Menu
Interfaces
>
Display EtherNet/IP data
12168
To display the EtherNet/IP data:
1 Select the menu page
►
>
>
►
Select [Data] tab.
2 Display EtherNet/IP data
>
Page shows the following information:
Designation
Meaning
Possible values
[MAC-ID]
MAC ID of the EtherNet/IP interface
e.g.
00:02:01:01:27:CF
[RPI Zeit]
RPI time in milliseconds [ms]
(RPI = Requested Packet Interval)
[Analog.
channels/O-slave]
Number of analogue channels per
input slave
→
Set the device-specific parameters
(
→ page
[Analog.
channels/O-slave]
Number of analogue channels per
output slave
→
Set the device-specific parameters
(
→ page
[Failsafe state]
Behaviour of the AS-i outputs in case
of an interrupted EtherNet/IP
connection
→
Set the device-specific parameters
(
→ page
[Parameter download]
The AS-i slave parameters are
transferred when a EtherNet/IP
connection is established.
Parameter can only be configured
via the projection software!
=
Parameters are not downloaded, i.e. the
AS-i slaves are activated using the
parameters that are set in the device.
=
Each time a EtherNet/IP connection is
established, the AS-i slave parameters
are loaded from the EtherNet/IP controller
to the device, activated in the slaves and
stored non-volatilely.
[Change byte order]
Byte order in a data word
The set parameter value applies
to all attached tables.
→
Set the device-specific parameters
(
→ page
>
Display the module configuration
12193
To display the current module configuration:
1 Select the menu page
►
>
>
.
►
Select [Module configuration] tab.
2 Display the module configuration
>
The page shows the active configuration of the EtherNet/IP slots.
(Meaning of parameter values:→
Set the EtherNet/IP module configuration
(→ page