IFM Ecomat 300 AC1421, Device Manual

Page: 99 / 365

99
ifm Device Manual SmartSPS AC14 with EtherNet/IP interface (AC1421, AC1422), Firmware 3.1.2 2015-11-30
Menu Interfaces
>
Set the device-specific parameters
15909
The parameters can only be changed if the configuration mode is set to Independent (
→ Set
the configuration mode
(
→ page
98 )).
To set the device-specific parameters: set the number of channels to be transmitted per analogue
input slave:
1 Select the menu page
► > >
► Select [Parameter] tab.
2 Set the number of analogue channels per input slave
►
Set the following parameter as required:
Parameter Meaning Possible values
[Analog. channels/I-slave] Number of analogue
channels transmitted per
input slave
1 channel per A/B
= 1 channel per A/B slave
OR:
channels 1 + 3 per single slave
1 channel = 1 channel per single slave
OR:
1 channel per A slave
2 channels
= 2 channels per single slave
OR:
2 channels per A slave
4 channels = 4 channels per single slave
OR:
2 channels per A/B slave
3 Set the number of analogue channels per output slave
►
Set the following parameter as required:
Parameter Meaning Possible values
[Analog.
channels/O-slave] Number of analogue
channels transmitted per
output slave
1 channel per A/B
= 1 channel per A/B slave
OR:
channels 1 + 3 per single slave
1 channel = 1 channel per single slave
OR:
1 channel per A slave
2 channels
= 2 channels per single slave
OR:
2 channels per A slave
4 channels = 4 channels per single slave
OR:
2 channels per A/B slave