![background image](http://html1.mh-extra.com/html/ifm/ecomat-300-ac1421/ecomat-300-ac1421_device-manual_3914776346.webp)
346
ifm
Device Manual SmartSPS AC14 with EtherNet/IP interface (AC1421, AC1422), Firmware 3.1.2
2015-11-30
Appendix
OSC messages
>
8.8.1
OSC messages: System
14284
Message
Type
Corrective measures
An internal device error was detected
<Fehlernummer>
Error
► Note the message and contact the ifm service center
Permitted temperature limit value inside the
device was exceeded (<xxx.x> °C)
Warning
► Check thermal conditions of the system environment
First operation after delivery
Event
not necessary
The output control was set to
<Gateway,manuell,SPS>
Event
not necessary
System power-up completed, <SW-Version>
Event
not necessary
A system reset was requested manually
Event
not necessary
The user-specific message history was deleted.
Event
not necessary
The device was reset to factory settings via
<HMI, Feldbus>.
Event
not necessary
PLC used for more than 10 hours.
Event
not necessary
The project <Name> was loaded.
Event
not necessary
The PLC was set to the operating mode
<Projektierungsmodus, geschützter Betrieb>.
Event
not necessary
The firmware was updated from <FW-Version>
to version <FW-Version>.
Event
not necessary
The settings of the fieldbus interface were
modified
Event
not necessary
The fieldbus connection was established
Event
not necessary
The fieldbus connection was aborted
Event
not necessary
The IP settings of the configuration interface
were changed
Event
not necessary