![background image](http://html1.mh-extra.com/html/ifm/ecomat-300-ac1421/ecomat-300-ac1421_device-manual_3914776163.webp)
163
ifm
Device Manual SmartSPS AC14 with EtherNet/IP interface (AC1421, AC1422), Firmware 3.1.2
2015-11-30
Appendix
Fieldbus EtherNet/IP
>
Parameter setting via the configuration assembly object
Device-specific parameters ..................................................................................................................164
Parameters of the fieldbus slots ...........................................................................................................174
Derivation of parameter values for free slave assignment ...................................................................180
12810
In
→
Configuration mode: Top-down
(
), the parameter data are set in the EtherNet/IP
projection software (
→
Configuration mode: Top-down
(
)). By means of the configuration
assembly object, the configuration is then transferred to the device and activated.
Only when a connection is established by the I/O scanner will the parameter data configured
via the configuration assembly object be transferred to the device. Changes to the parameter
data in the online mode of the controller will therefore only become effective after the next
connection.
To trigger a new connection setup, perform one of the following actions:
Reboot the device
Perform a system reset (
→
System reset
(
Briefly interrupt the EtherNet/IP connection between the I/O scanner and the device
Transfer the project from the higher-level controller to the device (download)
Restart the I/O scanner
The configuration in top-down mode includes the following parameters:
Parameters of the fieldbus slots
(
Device-specific parameters
(