IDTECK Star FINGER006, User Manual

Page: 24 / 51

24
11. Operation
11.1 Normal Operation
Power On
When the power is applied to FINGER006 , the “RED LED” is turned on.
Fingerprint Identification
1. If registered card is read by the unit, red LED of fingerprint sensor is on.
At this time, you should put your finger and then remove your finger if red LED is off.
2. If fingerprint identification is done, card ID or authorization status appears on the
LCD.
Registered Card Reading
When a registered card (or PIN) is read, the door (Relay1) will open for 3 seconds
(Defaults) with the “GREEN LED” on.
Exit Button
To make a request for exiting from inside, an Exit Button (Or External Reader) can be used.
The Door (Relay1) will open for 3 seconds (Defaults) with the on.
Alarms (Unregistered / Password / Fingerprint )
When an unregistered card is read, wrong password is input, wrong fingerprint is input, the
access is denied and the alarm (Relay 2) will be activated for 3 seconds (Defaults) with “RED
LED” on.
11.2 Default Setting
When you operate the FINGER006 first time or you initialize the FINGER006 , the
FINGER006 will set up all values to default settings (Factory Settings). You can change
the settings for desired application. Please refer to the “APPENDIX” section at the back
of this manual for the default setting values.