IDTECK Star FINGER006, User Manual

Page: 43 / 51

43
12.4.8 COMMUNICATION TEST
12.4.9 IDENTIFICATION MODE
12.4.10 DUAL FINGERPRINT MODE
DUAL
FINGER
MODE
Number of Templates and Fingers
Authentication
Success Ratio
Recommended
Authentication Mode
NOT USE
2 Storage Templates for a single finger. High Identification Mode
USE 1 Storage Template each for 2 different
fingers.
Low Verification Mode
8. COMM TEST
COMM Test allows you to test communication. Prior to the
test, connect the RS232-RX wire (Black wire with White stripe)
and the RS232-TX wire (Red wire with Black stripe) together.
To begin the test, press
<ENT> . If the test is successful, the
LCD will display the “TEST PASSED” message. Press any
key to finish the test. If the test is unsuccessful, the LCD will
display the “TEST FAILED” message. Press any key to finish
the test and try again after powering the FINGER006 off and
back on.
TEST PASSED!!!
PRESS ANY KEY…
9. IDENTIFICATION
Identification Mode is a feature that allows users to use just
fingerprint verification without having to present their cards or
enter their ID numbers. If this feature is enabled, a user can
just place the fingerprint onto the fingerprint scanner, and then
the FINGER006 will perform 1: N authentication for all
fingerprint templates in the database and grant access if a
fingerprint template that matches the user’s fingerprint is
found.
9. IDENTIFICATION
- > ENABLE
10. DUAL FINGER
The Dual Fingerprint Mode allows one user to register two
different fingerprints per ID. This feature is useful when a
user’s finger is injured and wishes to use the other registered
finger in the verification process.
To enable or disable the “Dual Fingerprint Mode”, press
<ENT> and press <4> or <6> to select “ENABLE” or
“DISABLE” and press <ENT> to confirm.
10. DUAL FINGER
- > DISABLED
TEST FAILED!!!
PRESS ANY KEY…