TURBOCAR
Installation
4
0.0
7/22
INST
AL
L
AT
IO
N
Finally, mount the wheels and fix them with the appropriate nuts (fig. 4.5.5), lifting the support (A),
operating the distributor lever, after connecting the distributor to the hydraulic system (through
quick couplings to the tractor or through a diesel or petrol engine etc.).
(fig. 4.5.5)
5.2 ASSEMBLY OF THE DRAWBAR, EYE, BOOM FEET (WHERE PRESENT) AND
DRAWBAR LIFTER FOOT/FEET:
In most cases the drawbar, the boom feet (where present) and eye as well are delivered
assembled on the machine. Should they be disassembled due to transport reasons,
assemble them as follows:
1) use a sling and forklift truck, crane or hoist, and lift the drawbar (M) to move it
near the plates or plate of the base (see arrows fig. 4.5.6 - 4.5.7), in order to be
able to fix it to the frame with screws, washer, Grover and nuts (fig. 4.5.6 - 4.5.7);
2) prepare the eye (N) and fix it with pins and cotters in the preferred position (fig.
4.5.6 - 4.5.7 – 4.5.7 – 4.5.9);
3) mount the boom feet (where present), adjust the required height and block them
with pin and cotter (fig. 4.5.10);
4) The drawbar lifter foot/feet (O) and the compressor (P) (if any) are almost always
already mounted on the drawbar, as they are connected to the machine’s
hydraulic and water system; if they are disassembled, the foot and the
compressor must be moved near the coupling on the drawbar and fixed with
screws, washers, Grover and nuts to the plate on the drawbar (see arrows fig.
4.5.11 – 4.5.12) as well as connecting to the foot the oil pipes of the hydraulic
system (see arrows fig. 4.5.11).
(fig. 4.5.6) (fig. 4.5.7)
(fig. 4.5.8)
(fig. 4.5.9)
(fig. 4.5.10)
(fig. 4.5.11) (fig. 4.5.12)