TURBOCAR
Safety
3
0.0
2/10
SAF
ET
Y
IMPORTANT!
The manufacturer disclaims any liability for damage caused by the Machine to
persons, animals or property in the event of:
-
use of the Machine or intrusion in the area of operations by personnel not
adequately trained;
-
misuse of the machine;
-
supply and hydraulics defects;
-
incorrect installation;
-
deficiencies in the scheduled maintenance;
-
unauthorised modifications or operations;
-
use of non original spare parts or non specific for the model;
-
total or partial failure to comply with the instructions;
-
use against specific national regulations;
-
natural disasters and exceptional events.
General requirements
Movable elements must always be used according to the manufacturer’s requirements, as
indicated in this Manual, which must always be available in the workplace.
All safety equipment fitted on movable elements to prevent accidents and assure safety cannot
be modified or removed, but must be adequately maintained.
The User must promptly inform the employer or their direct superior of any defects or faults
observed in the movable elements.
Checks and inspections
Checks must be performed as indicated in the relevant chapter of this booklet.
If worn or defective parts are not promptly replaced, the manufacturer disclaims any liability for
the damage from any accidents that might derive.
The checks must be performed by an experienced person. They must be visual and functional,
with the purpose of assuring machine safety. They include:
check of all load-bearing structures, which must show no crack, breakage, damage,
deformation, corrosion, wear or alteration compared to the original features;
check of all mechanical parts;
check of all safety devices installed on the Machine;
check of all connections with pins and screws;
functional inspection of the Machine;
inspection of the Machine’s condition;
check of the tightness and efficiency of the Hydraulic system.
The results of this check must be entered in an appropriate card.
ATTENTION!
If faults are observed, they must be removed before starting the Machine up
again, and the expert who performs the check must note down on the card the
successful repair, thus approving the Machine for use.
If they find any dangerous cracks or abnormalities, the person who performs the check must
promptly inform the Machine’s manufacturer.