![background image](http://html1.mh-extra.com/html/icom/ic-r9500/ic-r9500_instruction-manual_3629681109.webp)
8-11
8
SCANS
■
Memory scan
All memory channels (except skip channels) in the se-
lected bank are scanned at up to
40 ch/sec
.
D
D
Setting
q
Push [EXIT/SET] several times to close a multifunc-
tion screen, if necessary.
w
Push [F-5•SCAN] to select scan setting screen.
e
Push [F-4•MEMO] once to enter the bank selection.
r
Rotate the main dial to select the bank limit setting.
• Selected bank number or OFF (Bank OFF) appears.
t
Or rotate [BANK] to select the other bank.
y
Push [F-4•MEMO], then rotate main dial to select
the edge channel.
u
Push [F-4•MEMO], then rotate main dial to select
the other edge channel.
i
Push [F-4•MEMO], then rotate main dial to select
the desired select memory channel group for select
memory scan.
• ‘
★
1’ to ‘
★
9’ and ‘ALL’ are available.
o
Push [F-4•MEMO] to set the memory scan.
[F-4•MEMO] [EXIT/SET] Main dial [BANK]
D
D
Memory scan operation
q
Push [EXIT/SET] several times to close a multifunc-
tion screen, if necessary.
w
Set the [SQUELCH] control open or closed.
• See page 8-3 for squelch condition.
e
Push [MEMO] to start the memory scan.
• Scan screen appears and memory mode is selected au-
tomatically.
• “
” and decimal points blink during
memory scan.
r
When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
t
To cancel the scan, push [MEMO].
• Pushing [F5•STOP] also cancels the scan.
• Pushing [EXIT/SET] closes the scan screen.
2 or more memory channels must be programmed
for memory scan to start.
MEMORY SCAN
[EXIT/SET]
[MEMO]
[SQUELCH]