8-8
8
SCANS
■
∂
F scan
∂
F scan scans a small range of frequencies around an
operating frequency.
∂
F scan center frequency can be
set as specific frequency or as the operating frequency.
D
D
Setting
q
Push [EXIT/SET] several times to close a multifunc-
tion screen, if necessary.
w
Push [F-5•SCAN] to select scan setting screen.
e
Push [F-3•
∂
F] once to enter the center frequency
setting.
r
Rotate the main dial to select the
∂
F scan center
frequency to fixed frequency or variable frequency.
• Displayed frequency can be changed using the keypad.
• When fixed frequency is selected, frequency appears.
When variable frequency is selected,“---,---,--- MHz” ap-
pears.
t
Push [F-3•
∂
F] then rotate the main dial to set the
∂
F span.
• ±5 kHz, ±10 kHz, ±20 kHz, ±50 kHz, ±100 kHz,
±500 kHz and ±1000 kHz are selectable.
y
Push [F-3•
∂
F] to set the
∂
F scan.
[F-2•
:
F]
[EXIT/SET]
Main dial
D
D
∂
∂
F scan operation
q
Push [EXIT/SET] several times to close a multifunc-
tion screen, if necessary.
w
Select the desired VFO or memory channel.
e
Select the desired operating mode.
• The operating mode can also be changed while scan-
ning.
r
Set [SQUELCH] control open or closed.
• See page 9-2 for squelch condition.
t
Push [
∂
F] to start the
∂
F scan.
• Scan screen appears.
• “
” and decimal points blink while scanning.
• When the center frequency is fixed and the operating
frequency exceeds the scanning range,
∂
F scan jumps
to the fixed center frequency.
y
When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
u
To cancel the scan, push [
∂
F].
• Pushing [F5•STOP] also cancels the scan.
• Pushing [EXIT/SET] closes the scan screen.
i
Push and hold [F-6•RECALL] for 1 sec. to recall the
frequency that was set before starting the scan, if
desired.
:
F SCAN
Scan indicator and
∂
F scan indicator appear
[EXIT/SET]
[SQUELCH]
[
:
F]
