Preparing to Install Options
Preparing a Tower Model
The hard disk drives in Netfinity 5000 server are hot-swappable. If you are
installing only a hard disk drive (bays 1 through 5), go directly to “Installing or
Removing Internal Drives” on page 56. Otherwise, continue with the following
steps.
1. If you have a modem or fax machine attached to the server, disconnect the
telephone line from the wall outlet and the server.
Note: If you are in the United Kingdom, you must perform this step before
disconnecting the power cord.
6
CAUTION:
The Power-on switch on the front of the server does not turn off the
electrical current supplied to the server. The server also might
have more than one power cord. To remove all electrical current
from the server, ensure that all power cords are disconnected from
the power source.
2. Unplug all power cords (cables) from electrical outlets, and then disconnect all
other cables from the back of the server.
3. Open the server door, if you have not already done so.
4.
Remove the left-side cover.
a. Locate the cover-release lever on the front of the server and slide it to the
right.
Cover
Release
Lever
b. Slide the left-side cover back about 25 mm (1 inch); then, lift the cover and
remove it.
c. Store the cover in a safe place.
44
Netfinity 5000 Server Hardware Information and Procedures
