Installing the Rack Model in a Rack Enclosure
Installing the Server in the Rack Enclosure
In this section, you will use the following parts:
Four long screws (M6 by 16 mm)
Two cage nuts
One cable-management arm
Cable ties
To install the server into the rack enclosure:
1. If you have not done so already, install a cage nut in each front mounting rail in
the marked positions, as shown.
2. Position the Netfinity 5000 server horizontally, with the 3.5-inch drive bays on
the top.
3. Align the inner slides on the sides of the server with the slide rails; then, slide
the server onto the outer slide, until the slide rails click into place.
Note: When the rack model is fully extended, safety latches on the slide rails
lock into place. This prevents the server from being accidentally pulled
out too far and dropped. To release the safety latch, press in.
4. Press the safety latches and slide the rack model about halfway into the rack
enclosure.
102
Netfinity 5000 Server Hardware Information and Procedures
