Ethernet Controller Messages
PCNTND-15 Device not found.
Explanation: The driver cannot find an Ethernet controller in the server.
Action: Verify that the PCI Ethernet device type is set to the default (enabled) position in the
Configuration/Setup utility programs (see “PCI Bus Control” on page 29). If the Ethernet adapter is
enabled, go to “Diagnostic Test Programs” on page 111 to run the diagnostic utility.
PCNTND-16 PCI scan specified, device not found.
Explanation: The driver cannot locate the Ethernet controller on the PCI bus.
Action: Verify that the PCI Ethernet device type is set to the default (enabled) position in the
Configuration/Setup utility programs (see “PCI Bus Control” on page 29). If the Ethernet adapter is
enabled, go to “Diagnostic Test Programs” on page 111 to run the diagnostic utility.
PCNTND-21 The adapter failed the checksum test.
Explanation: The driver cannot find an Ethernet controller.
Action: Verify that the PCI Ethernet device type is set to the default (enabled) position in the
Configuration/Setup utility programs (see “PCI Bus Control” on page 29). If the Ethernet adapter is
enabled, go to “Diagnostic Test Programs” on page 111 to run the diagnostic utility.
PCNTND-23 WARNING: PCNET IRQ found
=
xx
Explanation: The interrupt request (IRQ) setting (
xx) in the PROTOCOL.INI file does not match the
hardware IRQ setting.
Action: Remove the IRQ setting from the PROTOCOL.INI file or change the IRQ setting in the
PROTOCOL.INI file to match the IRQ setting shown in the PCI Routing selection of the System
Information menu in the Configuration/Setup Utility. (See “PCI Routing” on page 23.)
PCNTND-24 WARNING: PCNET IRQ does not match PROTOCOL.INI.
Explanation: The interrupt request (IRQ) setting in the PROTOCOL.INI file does not match the
hardware IRQ setting.
Action: Remove the IRQ setting from the PROTOCOL.INI file or change the IRQ setting in the
PROTOCOL.INI file to match the IRQ setting shown in the PCI Routing selection of the System
Information menu in the Configuration/Setup Utility. (See “PCI Routing” on page 23.)
PCNTND-25 PCI scan specified, PCI bus not found!
Explanation: The driver cannot locate the PCI bus on your server.
Action: Go to “Diagnostic Test Programs” on page 111 to run the diagnostic utility.
PCNTND-29 WARNING: DMA number is not necessary for PCI device.
Explanation: The Ethernet controller does not require a DMA setting.
Action: Remove the DMA setting in the PROTOCOL.INI file.
PCNTND-33 PCNET device with specified IOBASE is already in use.
Explanation: The specified I/O address number is already in use by another Ethernet controller or
device.
Action: Remove the I/O address setting in the PROTOCOL.INI file.
Chapter 6. Solving Problems
139
