IBM 6H0, Service Manual

Page: 232 / 561

Table 5. Firmware Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
2B2x xx11 Processor is manually disabled Use the service processor menus to
re-enable the processor and reboot
the system
2B20 0022 Processor is deconfigured by the
system
1. Replace the processor card.
Location: U1.1-P1-C1
2. CEC backplane
Location: U1.1-P1
2B2x xx31 Processor is failing POST Replace the processor card.
Location: U1.1-P1-C1
2B20 0031 Processor is failing POST or is
manually disabled.
1. If the processor is not enabled,
then use the service processor
menus to enable the processor.
Then reboot the system.
2. If the processor is failing POST,
then replace the processor card
at the location specified in the
error log.
Location: U1.1-P1-C1
2B20 0042 Unknown processor card Remove the unknown processor
card.
2BA00000 Service processor POST failure Replace primary I/O backplane
Location: U0.1-P1
2BA0 0012 Service processor reports self test
failure
Replace primary I/O backplane
Location: U0.1-P1
2BA0 0013 Service processor reports bad
NVRAM CRC
If problem persists, replace primary
I/O backplane
Location: U0.1-P1
2BA0 0017 Service processor reports bad or low
battery.
1. Replace the battery.
2. Replace primary I/O backplane
Location: U0.1-P1
2BA0 0041 Service processor VPD is corrupted. Replace primary I/O backplane
Location: U0.1-P1
2BA0 0080 Service processor reports memory
riser card VPD module not present.
Replace memory card (s).
2BA0 0081 VPD data corrupted for memory riser
card in slot 0.
Replace memory card in slot 0.
2BA0 0083 VPD data corrupted for memory riser
card in slot 1.
Replace memory card in slot 1.
212
Service Guide