IBM 6H0, Service Manual

Page: 246 / 561

Table 6. Service Processor Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
4068 00A3 Other bus processor runtime
diagnostics detected memory
plugging fault
All pluggable memory.
Go to “MAP 1540: Minimum
Configuration” on page 113 and run
CEC drawer minimum configuration
to isolate the failing memory
component.
4068 00A4 Other bus processor runtime
diagnostics detected application
caused fault
Application software
4068 00A5 Other bus processor runtime
diagnostics detected invalid system
configuration
Verify system components are
supported and properly installed
4068 00A6 Other bus processor runtime
diagnostics detected no usable
memory
1. Ensure that memory DIMMS and
cards are properly installed
2. Go to service processor memory
configuration/deconfiguration
menu to verify memory DIMMs
state. See
″
Memory
Configuration/Deconfiguration
Menu
″
on page 384 for more
information.
3. Go to “MAP 1540: Minimum
Configuration” on page 113.
4068 00A7 Other bus processor runtime
diagnostics detected hardware
problem
Go to “MAP 1540: Minimum
Configuration” on page 113.
4068 00B0 Other bus processor runtime
diagnostics detected bus controller
lock-unlock failure
RIO adapter
Location: U0.1-P1.1
4068 00B1 Other bus processor runtime
diagnostics detected bus controller
failure
RIO adapter
Location: U0.1-P1.1
4068 00B7 Other bus processor runtime
diagnostics detected insufficient
hardware resources to continue IPL
This error code appears after the
initial testing by the service processor
firmware on the CEC was completed
correctly, but a problem occurred
when the firmware tried to
communicate outside the CEC.
Suspect a problem with the RIO
interface, either cables or adapters.
4068 0100 Other bus processor runtime
diagnostics detected memory riser
card fault
Memory riser card
Location: U1.1-P1-M2
4068 0101 Other bus processor runtime
diagnostics detected memory DIMM
fault
Memory DIMM
Location: U1.1-P1-M2.15
226
Service Guide