IBM 6400 Series, Setup Manual

Page: 241 / 316

Fault Correction Procedure
241
069 DATA CLEARED N/A Appears when data is
cleared out of printer
after
Cancel key has
been pressed.
No action necessary.
080 POWER SUPPLY HOT No Circuits are overheating
on the power supply
board. Contact your IBM service
representative.
082 POWER SUPPLY 8.5V
FAILED No Internal power failure. Contact your IBM service
representative.
083 INTAKE FAN FAULT Yes Sensors cannot detect
current in fan circuit. Power off the printer.
Check for obstruction of
vents and fan airway;
remove any obstructions.
Check for items beneath
the printer blocking cabinet
vents. Power back on the
printer. If this message
reoccurs, contact your IBM
service representative.
084 POWER SUPPLY 48V
FAILED No Internal power failure. Contact your IBM service
representative.
085 CONTROLLER
VOLTAGE No Controller voltage failure. Contact your IBM service
representative.
086 CONTROLLER 15V No Controller voltage failure. Contact your IBM service
representative.
087 PLATEN OPEN
TIMEOUT
CLOSE PLATEN
Yes Forms thickness lever
has been open for at
least one minute. Close forms thickness
lever.
088 CONTROLLER 23.5V No Controller voltage failure. Contact your IBM service
representative.
089 RIBBON STALL
CHECK RIBBON
Yes No ribbon movement. Make sure the ribbon is not
twisted and the forms
thickness lever is set to
match thickness of media
being used. If fault
reoccurs, contact your IBM
service representative.
Table 11: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution