IBM 6400 Series, Setup Manual

Page: 171 / 316

Code V Configuration Menu
171
Width Limit
•
Disable . (the default.) This does not limit the width of expanded
characters.
•
Enable . When enabled, limits the width of expanded characters based on
a fixed maximum ratio of width over height.
Absorb at ^PN
•
Disable . (the default.) When disabled, system terminators following the
(cc)PN command are sent to the printer and result in paper motion.
•
Enable . Prevents paper motion following the (cc)PN command.
IGP110 Compatibility
•
Enable . (the default.) This menu will process ^IPEXP commands in the
same manner the IGP does, and does not expand special font characters
if an ^IPEXP command precedes it.
•
Disable . If disabled, it will allow the special font characters to be
expanded.
Inline Graphics
•
Enable . Permits Code V graphics to start in the middle of a print line as
opposed to moving to the beginning of the line to start a graphic.
•
Disable . (the default.) Requires the printer move to the beginning of the
line to start a graphic.
Error Handling
•
Error Messages
•
Disable . Suppresses error checking and error messages.
•
Enable . (the default.) Checks command syntax and prints error
messages when command parameters are incorrect.
•
Error Markers
•
Enable . (the default.) Prints the following error markers for those
elements that print beyond the page boundaries:
>> for elements that begin off the right side of the page;
<< for elements that begin at the indicated position but end off the
page
for elements where the starting position of the command contains
an error other than an off-page error.
•
Disable . Does not print error markers for those elements that print
beyond the page boundaries.