IBM 6400 Series, Setup Manual

Page: 299 / 316

299
Index
Numerics
001 END OF FORMS, 236
002 FORMS JAMMED, 236
003 FORMS EJECTED, 236
004 VIEW FORMS, 236
006 HOST SYSTEM REQUEST ATTENTION, 236
007 FM HEADER ERROR, 236
008 HOLD PRINT TIMEOUT, 236
009 INVALID KEYPRESS, 236
010 PARAMETER ERROR, 236
011 SCS COMMAND ERROR, 237
012 STRUCTURED FIELD ERROR, 237
013 ACTIVATE LOST, 237
014 INVALID ACTIVATE, 237
015 COMMUNICATION CHECK, 237
016 INVALID COMMAND, 237
017 STACKER JAM, 237
018 STACKER FULL, 237
019 STACKER FAULT, 237
021 RECEIVE BUFFER OVERRUN, 237
022 UNIT ADDRESS NOT RECEIVED, 237
024 SERIAL LINE PARITY ERROR, 238
025 SERIAL FRAMING ERROR, 238
026 HEX DUMP MODE, 238
027 COMMUNICATION CHECK, 238
028 COMMUNICATION CHECK, 238
029 8344 DIAGNOSTIC TEST FAILED, 238
031 END OF FORMS TIMEOUT, 238
032 FORMS JAMMED TIMEOUT, 238
034 RIBBON STALL TIMEOUT, 238
037 STACKER JAM TIMEOUT, 239
038 STACKER FULL TIMEOUT, 239
039 STACKER FAULT TIMEOUT, 239
041 BUFFER OVERFLOW, 239
042 CUSTOM SET DOES NOT EXIST, 239
043 CUSTOM SET ALREADY EXISTS, 239
044 EC FIRMWARE/HARDWARE ERROR, 239
046 EC STOPPED AT STATE, 239
056 HAMMER COIL OPEN, 240
057 CLOSE PLATEN, 240
058 SHUTTLE JAM, 240
059 CANCEL PRINT ACTIVE, 240
060 PRINTER HOT, 240
062 EXHAUST FAN FAULT, 240
065 HAMMER BANK FAN FAULT, 240
069 DATA CLEARED, 241
080 POWER SUPPLY HOT, 241
082 POWER SUPPLY 8.5V FAILED, 241
083 INTAKE FAN FAULT, 241
084 POWER SUPPLY 48V FAILED, 241
085 CONTROLLER VOLTAGE, 241
086 CONTROLLER 15V, 241
087 PLATEN OPEN TIMEOUT, 241
088 CONTROLLER 23.5V, 241
089 RIBBON STALL, 241
090 SHUTTLE COVER OPEN, 242
092 RIBBON DRIVER CIRCUIT, 242
101 UPPER DRIVER SHORT, 242
102 LOWER DRIVER SHORT, 242
11 inch pages, 204
110 STACK OVERFLOW, 242
111 STACK UNDERFLOW, 242
112 UNDEFINED OP CODE, 242
113 PROTECTED INSTRUCTION, 242
114 ILLEGAL OPERAND ACCESS, 242
115 ILLEGAL INSTRUCTION ACCESS, 243
116 ILLEGAL EXTERNAL BUS ACCESS, 243
117 A TO D OVERRUN, 243