7-56
While pushing the washer (2-8),
assemble the snap ring (2-9).
Set the piston assembly (2-13) on the
retainer plate (2-12) and assemble it in
the cylinder block (2-5).
Apply an ample amount of hydraulic fluid
to the sliding part before assembly.
Apply grease to the pin (2-10) and
assemble it in the cylinder block (2-5).
Assemble the retainer holder (2-11).
Press-fit the ball bearing (2-2) on the
shaft (2-3).
Press-fit the ball bearing (2-2) with the
attached snap ring facing as shown in
the figure.
2-8
2-9
2-11
2-10
2-12
2-13
2-2
2-3
Snap ring
Λ
Μ
Ν
Ξ
ö
R35Z77SM35
R35Z77SM11
R35Z77SM10
R35Z77SM36
Ο
ö
