WHAT TO DO IN AN EMERGENCY
WHAT TO DO IN AN EMERGENCY
WHAT TO DO IN AN EMERGENCY
WHAT TO DO IN AN EMERGENCY
WHAT TO DO IN AN EMERGENCY
3-5
Wheel nut
Wrench
The wheel nuts should be loosened slightly
before raising the car. To loosen the nuts, turn
the wrench handle counterclockwise. When
doing this, be sure that the socket is seated
completely over the nut so it cannot slip off. For
maximum leverage position the wrench so the
handle is to the right as shown in the drawing.
Then, while holding the wrench near the end of
the handle, pull up on it with steady pressure.
Do not remove the nuts at this time. Just loosen
them about one-half turn.
D060E01A-AAT
4. Put the Jack in Place
4. Put the Jack in Place
4. Put the Jack in Place
4. Put the Jack in Place
4. Put the Jack in Place
The base of the jack should be placed on firm,
level ground. The jack should be positioned as
shown in the drawing.
D060F02E-AAT
5. Raising the Car
5. Raising the Car
5. Raising the Car
5. Raising the Car
5. Raising the Car
D060G01A-AAT
6. Changing Wheels
6. Changing Wheels
6. Changing Wheels
6. Changing Wheels
6. Changing Wheels
AS30120A
After inserting a wrench bar into the wheel nut
wrench, install the wrench bar into the jack as
shown in the drawing. To raise the vehicle, turn
the wheel nut wrench clockwise. As the jack
begins to raise the vehicle, double check that it
is properly positioned and will not slip. If the
jack is on soft ground or sand, you may find it
necessary to place a board, brick, flat stone or
other object under the base of the jack to keep
it from sinking.
Raise the car high enough so that the fully
inflated spare tire can be installed. To do this,
you will need more ground clearance than is
required to remove the flat tire.
WARNING:
WARNING:
WARNING:
WARNING:
WARNING:
Do not get under the car when it is sup-
Do not get under the car when it is sup-
Do not get under the car when it is sup-
Do not get under the car when it is sup-
Do not get under the car when it is sup-
ported by the jack. This is very dangerous
ported by the jack. This is very dangerous
ported by the jack. This is very dangerous
ported by the jack. This is very dangerous
ported by the jack. This is very dangerous
as the vehicle could fall and cause serious
as the vehicle could fall and cause serious
as the vehicle could fall and cause serious
as the vehicle could fall and cause serious
as the vehicle could fall and cause serious
injury or death. No one should stay in the
injury or death. No one should stay in the
injury or death. No one should stay in the
injury or death. No one should stay in the
injury or death. No one should stay in the
car while the jack is being used.
car while the jack is being used.
car while the jack is being used.
car while the jack is being used.
car while the jack is being used.
Use the wrench to loosen the wheel nuts, then
remove them with your fingers. Remove the
wheel cover (if installed) from the wheel and
slide the wheel off the studs and lay it flat so it
cannot roll away. To put the wheel on the hub,
pick up the spare tire, line up the holes with the
studs and slide the wheel onto them. If this is
difficult, tip the wheel slightly and get the top
hole in the wheel lined up with the top stud.
Then jiggle the wheel back and forth until the
wheel can be slid over the other studs.
D060E01A
<PRIME>
D060E01V
HFC4022
Wrench bar
