FEATURES OF YOUR HYUNDAI
1-23
reason, do not operate the washer when the
washer fluid reservoir is empty.
B340G02X-GAT
HEADLIGHT LEVELING DEVICE SYS-
TEM
To adjust the headlight beam level according to
the number of the passengers and the loading
weight in the luggage area, turn the beam
leveling switch. The higher the number of the
switch position, the lower the headlight beam
level. Always keep the headlight beam at the
proper leveling position, or headlights may daz-
zle other road users. Listed below are the
examples of recommanded switch settings. For
loading conditions other than those listed be-
low, adjust the switch position so that the beam
level may be the nearest as the condition ob-
tained according to the list.
B340G01A-DAG
B390A01X-GAT
REAR WINDOW WIPER AND WASHER
(Not all models)
B390A01X-DAG
To operate the rear wiper and washer, turn the
barrel on the end of the multifunction switch.
1. OFF
2. When the point indicates the , the rear
windshield wiper starts to operate continu-
ously.
3. The washer fluid will be spray onto the rear
winshield by indicating the point onto the .
The wiper operates continuously after the
washer fluid is sprayed.
Do not operate the washer continuously for
more than 15 seconds or when the fluid reser-
voir is empty; this could damage the system.
Do not operate the wiper when the window is
dry; this can result in scratching as well as
premature wiper blade wear. For the same
1
2
3
The hazard warning system should be used
whenever you find it necessary to stop the car
in a hazardous location. When you must make
such an emergency stop, always pull off the
roadway as far as possible.
To turn on the hazard warning lights, push the
hazard switch. This causes all turn signal lights
to blink. The hazard warning lights will operate
AB160A1-A
HAZARD WARNING SYSTEM
XV10590E
Loading condition
Driver only
front passenger
Full passengers
(including driver)
Full passengers (including
driver) + Permissible load
Permissible load
Switch position
0
0
1
1
2