Hypertherm SYNC Powermax 105, Operator'S Manual

Page: 77 / 174

Operate the Plasma System
3
Powermax65/85/105 SYNC Operator Manual 810470 77
Go back to automatic gas pressure mode
To go back to automatic gas pressure mode , push . The LED next to the button goes off.
The system also goes back to automatic gas pressure mode when you install a different type of
cartridge.

When you change from manual gas pressure mode to automatic gas pressure mode ,
the plasma power supply automatically sets the gas pressure related to the Hypertherm
cartridge, but the amperage setting stays the same.

When you change from automatic gas pressure mode to manual gas pressure mode ,
the plasma power supply uses the last manual gas pressure that you set, and the amperage
setting stays the same.

When you do a quick restart or a cold restart of the plasma power supply in manual
gas pressure mode , the plasma power supply keeps the last manual gas pressure and
amperage that you set unless you install a different type of cartridge.
Adjust the operating mode manually
The plasma power supply automatically sets the operating mode related to the type of Hypertherm
cartridge that you install.

When you install a Hypertherm cutting cartridge or FineCut
cartridge, the plasma power supply goes to
Cut mode .

Push the button to move from Cut mode to Expanded Metal
mode.

Move the torch-lock switch to the green “ready to fire” ( )
position before you set the operating mode.

Gouge mode is not available.

When you install a Hypertherm gouging cartridge, the plasma
power supply goes to
Gouge mode.

Cut mode and Expanded Metal mode are not available.